SATO SG112-ex Operator's Manual page 73

PRINT OFFSET
Print Position Offset — which refers to the vertical and horizontal shifting of
the entire print area, relative to the start position of printing (V=0, H=0),
defined by default to be the bottom right hand corner of the media.
When setting the print position in the vertical direction "V":
Set the offset value with '+' from the print reference position to move the
print position opposite the feed direction and value with '-' to move the print
position in the feed direction.
When setting the print position in the horizontal direction "H":
Set the offset value with '+' from the print reference position to move to the
left side and value with '-' to move to the right side of the product (when
facing the front of the product).
The setting range is as follows:
V: ±0 to 5040 dot H: ±0 to 3200 dot
ZERO SLASH
Set whether to print the number zero (0) with or without a slash (/).
• YES: Print zero with a slash.
• NO: Print zero without a slash.
Applicable to X21, X22, X23, X24, XU, XM, XS, XB, XL fonts.
CHARACTER PITCH
Set the character width for printing.
• PROPORTIONAL: Print each character with a different width.
• FIXED: Print all characters with the same width.
4 Operation and Configuration
V (+)
H (+) H (-)
V (-)
ref point 0,0
Media feed direction
SG112-ex Operator Manual
71