SATO SG112-ex Operator's Manual page 156

5 Adjusting the Product
Example 2
For PITCH POSITION= 0mm / OFFSET POSITION= -3.00mm (-0.12")
a) Single media cut
Distance between the cut
position and print position
*1. The original backfeed distance before adjustment is 39.2 mm (1.5"), however it is adjusted to 36.2 mm (1.4") in this case to prevent the
media from falling off the platen roller area.
*2. To resolve the misalignment of print due to decreased backfeed length, adjust print starting line to +3mm (+0.12") from the original stop
position.
a) Multiple media cut
Distance between the cut
position and print position
*1. The original backfeed distance before adjustment is 39.2 mm (1.5"), however it is adjusted to 36.2 mm (1.4") in this case to prevent the
media from falling off the platen roller area.
*2. To resolve the misalignment of print due to decreased backfeed length, adjust print starting line to +3mm (+0.12") from the original stop
position.
154
SG112-ex Operator Manual
Cut position
36.2 mm
(1.4")
Platen roller
36.2 mm (1.4")
(*1)
3.0mm
(*2)
(0.12")
Base reference
point for printing
Cut position
36.2 mm
(1.4")
Platen roller
36.2 mm (1.4")
(*1)
3.0mm
(*2)
(0.12")
Base reference
point for printing
Base reference point for printing
Original stop position (media will fall off).
+3.0 mm
(+0.12")
Edit Buffer
Base reference
point for printing
Base reference point for printing
Original stop position (media will fall off).
+3.0 mm
(+0.12")
Edit Buffer
Edit Buffer
Base reference
point for printing
Edit Buffer
Printable area