SATO SG112-ex Operator's Manual page 119

PRINTER TYPE AUTO SETTING
Enable or disable the switching of the operation mode by auto detection of
the cutter unit.
If ENABLE is selected, and the cutter unit is installed, CUTTER will be
automatically selected on the PRINTER TYPE screen.
Select DISABLE to use other print mode other than CUTTER when cutter
unit is installed.
PRINTER TYPE
Set the operation mode.
• TEAR OFF: After continuously printing the specified number of the
media, feed the media to the point to remove the media. After printing,
tear off the media manually. The media will be back to the print head
position for starting the next printing.
• CUTTER: Cut each media while printing the specified number of media.
You can specify this option if you have installed the cutter unit.
• PRINTER CUT: Allows you to continuously print and cut at the specified
media repeat. If no print data is received within the period specified for
[Eject Cut], the product will feed the media to the cut position and cut
the last printed media. You can specify this option if you have installed
the cutter unit.
• CONTINUOUS: Continuously print the specified number of media. The
media remains in position for printing at all times.
Note
If cutter unit is not installed, only TEAR OFF and CONTINUOUS are
available.
BACKFEED MOTION
Backfeed is applicable only if the print mode is set to cutter mode.
• AFTER: After cut, backfeed the front part of the next media to the print
head position.
• BEFORE: Before printing, backfeed the front part of the media to the
print head position.
• NONE: Do not backfeed.
4 Operation and Configuration
SG112-ex Operator Manual
117