SATO SG112-ex Operator's Manual page 13

Carrying the product
• Do not carry the product while loaded
with media or attached to an optional
external device. They could fall, possibly
resulting in injury.
• When setting the product on the floor or
a stand, make sure not to get your
fingers or hands trapped under the
product.
• Before moving the product, be sure to
power it off, unplug the power cord from
the outlet, and disconnect any connected
cables. Moving the product with the
power cord or cables still connected
could damage them, possibly resulting in
a fire, electric shock, or damage.
Do not place the product in areas with high
humidity
• Do not place this product in an area with
high humidity or where condensation
occurs. If condensation has occurred,
immediately power off the product, and
avoid using it until it is dried. Using the
product while condensation is on it could
result in a fire, electric shock, or damage.
Power cord and other cables
• Grab a power cord and other cables by
the plug when removing from the outlet
or connector port. Removing a power
cord and other cables by grabbing the
cord/cable area could result in exposure
of wires, breakage, fire, electric shock, or
damage.
• Do not place the power cord and other
cables near a heater or other sources of
heat. Doing so could result in melting of
the power cord and other cables
sheathing, fire, electric shock, or
damage.
Loading fan-fold media
• Be careful not to get injured when
handling the media inlet or the cover.
Caution
Loading media roll
• When loading a media roll, be careful not
to get your fingers trapped between the
media roll and the supply spindle.
Print head
• The print head is hot after printing. Be
careful not to get burned when replacing
media or cleaning immediately after
printing.
• Do not touch the print head with your
bare hands. Doing so could result in
injury or damage.
• To replace the print head, follow the
procedure in the Operator Manual. If the
Operator Manual does not contain this
procedure, avoid trying to replace it on
your own terms, and contact your SATO
reseller or technical support.
• When opening and closing the print
head, make sure that objects other than
media do not get caught. Otherwise, it
could result in injury or damage.
Cover
• When opening and closing the cover, be
careful not to get your fingers trapped in
between. Also, firmly hold the cover to
prevent it from closing unexpectedly.
Always keep the cover of the product closed
• Always have the cover of the product
closed when using. You could get injured
by touching the moving parts. Also, dust
or foreign objects could get inside,
possibly resulting in the product to
malfunction.
When not using the product for a long time
• When not using the product for a long
time, unplug the power cord from the
outlet to maintain safety.
During maintenance and cleaning
• When maintaining and cleaning the
product, unplug the power cord from the
outlet to maintain safety.
Before You Start
SG112-ex Operator Manual
11