SATO SG112-ex Operator's Manual page 133

TEST PRINT MODE
Select the test print contents.
• CONFIGURATION: Print the configuration settings of the product.
• BARCODE: Print the barcodes installed in this product.
• HEAD CHECK: Print the head check pattern of the selected media size
area.
• MEMORY: Print the contents of the memory in this product.
• FONT: Print the contents of the fonts installed in this product.
• FACTORY: Perform the factory test print.
TEST PRINT SIZE
Set the width of the test print in 1 cm (0.4") steps.
The setting range is from 13 to 26 cm (5.1" to 10.2").
Note
Shows only if TEST PRINT MODE is set to CONFIGURATION, BARCODE
or HEAD CHECK.
TEST PRINT SIZE
Select the width of the test print from LARGE or SMALL.
• LARGE: Test print in 26 cm (10.2") wide.
• SMALL: Test print in 13 cm (5.1") wide.
Note
Shows only if TEST PRINT MODE is set to FACTORY.
4 Operation and Configuration
SG112-ex Operator Manual
131