SATO SG112-ex Operator's Manual page 151

Adjust the stop position using the following procedure:
1
Make sure that the product is in offline mode.
2
Press the button to enter the adjustment
mode.
PITCH POSITION shows on the screen.
3
Press the ENTER button to go to the next
adjustment screen.
OFFSET POSITION shows on the screen.
4
Change the setting value. Press the
buttons to set the desired value.
Set the offset value with '+' to move the stop
position opposite the feed direction, and value
with '-' to move the stop position in the feed
direction.
The setting value is adjustable by 0.25 mm (0.01")
regardless of print resolution.
The setting range is from -3.75 mm (-0.15") to
+3.75 mm (+0.15").
5
Press the ENTER button to save the
setting and proceed to the next
adjustment screen.
/
5 Adjusting the Product
SG112-ex Operator Manual
149