Usb Interface Connection; Lan Interface Connection - SATO SG112-ex Operator's Manual

2 Installing the Product
2.3.3

USB Interface Connection

1
Make sure that the product is powered
off.
2
Connect the USB cable to the USB
connector (Type B) of the product.
• Use a cable that is compatible with the
standard of the interface board as stated in
Section 8.9.1 USB
orientation of the connector before you make
the connection.
• The USB interface is selected after connecting
the USB cable to the computer and the product, and powering on the product while the computer is
turned on.
3
Configure the interface settings.
Refer to Section 2.3.7 Interface Settings
Note
• If the product is powered on without installing the printer driver, Windows' Plug & Play runs. When using the
printer driver, do not power on the product while the USB cable is connected, until instructed in the
procedure for installing the printer driver.
• The recommended USB cable is the one within 2 meters (6.6 feet) length.
2.3.4

LAN Interface Connection

1
Make sure that the product is powered
off.
2
Connect the LAN cable to the LAN
connector of the product.
• Use a cable that is compatible with the
standard of the interface board as stated in
Section 8.9.2 LAN
orientation of the connector before you make
the connection.
3
Configure the interface settings.
Refer to Section 2.3.7 Interface Settings
Note
• The communication condition settings must be configured according to your network environment. Set the
IP address of the product.
• To use the printer driver, the communication protocol must be set to Status4. (The initial value for the
communication protocol for the product's LAN interface is Status4 ENQ.)
30
SG112-ex Operator Manual
Interface. Check the
for more details on interface settings.
Interface. Check the
for more details on interface settings.
USB
LAN