Note:
For the Ethernet switch to report alarms properly, you must also configure the IP
Note:
addresses for the Ethernet switches in the media servers.
Default IP addresses for the Ethernet switch
The following table shows the default values for the Ethernet switch.
Parameter
IP address for the Ethernet switch
Subnet mask for the Ethernet switch
IP address for the
trap receiver (media server)
For how to administer the SNMP subagent in the Ethernet switch, see
switch
on page 32.
Preparing to configure the Ethernet switch
Before you configure the Ethernet switch, you must complete the following prerequisites:
The Ethernet switch power cord is connected to the back of the switch and to the back of a
●
UPS.
The communication protocol on your computer has the following port settings so that you
●
can use your terminal emulation program:
- 9600 baud
- No parity
- 8 data bits
- 1 stop bit
- No flow control
Note:
Avaya Terminal Emulation and HyperTerminal are supported terminal emulation
Note:
applications.
If a Network Management System (NMS) is to monitor the Ethernet switch, you
●
coordinated the assignment of community names with the network administrator. If an
NMS is not used, you set the community names to unique string values.
Installing and Configuring the Avaya S8500 Media Server
Configuring the SNMP subagent in the Avaya Ethernet switch (if used)
Single control
network (CNA)
198.152.254.240
255.255.255.0
Customer provided
Duplicated control
network (CNB)
198.152.255.240
255.255.255.0
Customer provided
Configuring the Ethernet
February 2007
31