Configuring The Snmp Subagent In The Avaya Ethernet Switch (If Used); Default Ip Addresses For The Ethernet Switch - Avaya S8700-Series Installing And Configuring

Hide thumbs Also See for S8700-Series:

Quick start manual (28 pages)

Table Of Contents

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

116

117

118

119

120

121

122

Table of Contents

For the menus and commands to set these traps, see the user guide that comes with the SNMP

module.

Configuring the SNMP subagent in the Avaya Ethernet

switch (if used)

Important:

These procedures apply only to a new, Avaya-supplied uninterruptible power

Important:

supply (UPS) with a Simple Network Management Protocol (SNMP) module. Do

not use these procedures to set traps on a UPS that Avaya does not supply.

You must administer the Simple Network Management Protocol (SNMP) subagent in the Avaya

Ethernet switch to report alarms to the server when problems occur.

For the SNMP module to properly report alarms, you must configure a unique IP address for the

UPS on both the SNMP module and the server. This IP address can be a customer-provided

address or the Avaya-provided default address. At a minimum, you must configure the following

items:

The IP address

The subnet mask

The gateway IP address

The trap receiver IP address

The community string (get, set, trap)

The brand, the model, or the firmware load of the Ethernet switch that Avaya supplies can

change without notice. For this reason, this document does not provide specific instructions on

how to connect to and configure the SNMP subagent. For more information, see the

documentation that comes with the Ethernet switch. Also see the Basic Configuration section of

the Quick Start Guide and the documentation CD-ROM that comes with the Ethernet switch for

the default user ID, password, and configuration commands.

Note:

For the Ethernet switch to report alarms properly, you must also configure the IP

Note:

addresses for the Ethernet switches in the servers.

Default IP addresses for the Ethernet switch

For how to administer the SNMP subagent in the Ethernet switches see

Ethernet switch

both Ethernet switches.