ELECTRICAL
235
Fig. 365 - Removing tall light.
1. Stop light bulb holder. - 2. Direction signal light bulb holder. -
3. Direction signal light bulb. - 4. Lamp complete with gasket. -
5. Lamp locking plates to body.
LICENSE PLATE LIGHT
The license plate lamp is incorporated in the
rear bumper.
To replace the bulb, remove lens screws and
slide off the bulb, which is inserted
by
bayonet
coupling (fig. 366).
Fig. 366 - Removing license plate lamp.
1. Lllmp frame•• 2. Bulb. - 3. Bulb holder.
Fig. 367 - Removing instrument cluster for replacement of
bulbs.
1.
Six-insert insulated junction block (white). - 2. Six-insert insulated
junction block (red). - 3. Speedo cable.
INSTRUMENT CLUSTER LIGHTS
To replace instrument cluster light bulbs the
cluster must be partially removed
by
inserting a
screwdriver at its base; then slide off the bulb
holder.
Bulb holders and bulbs are inserted by bayonet
coupling (fig. 367).
REAR VIEW MIRROR LIGHT
The map light is incorporated in rear view mir-
ror (fig. 368).
Fig. 368 • Removing map light bulb.
1. Toggle switch.
~
2. Bulb.
~
3. Mirror clip.