Table of Contents
Advertisement
ROADSTER
301
J
2
/
o
I
5
Fig. 485 - Section view of the steering column and mounting bracket.
1. Steering column mounting brackf't. - 2. Ball bearings. - 3. Steering column. - 4. Upper universal joint. - 5. Universal joint-Io-column
screw and nut. - A. Lower groove•• B. Upper groove.
The .."lion detail on the far right evidenced by .,row iIIustratea the locking device of the
,t••
,lng column upper ball b••ring cone by ,nap
ring and .pring
plate.
Up to car wIth
path
serial N°
72H.
To do so just loosen the column mounting bracket
screws at the body shell as well as the nut and
screw (5) securing the upper yoke of the joint (4).
Next work on the steering wheel so to set the
joint yoke into the lower groove.
Secure the yoke and the bracket in place, tight-
ening down on the screws and nut.
Pulling Wheel.
In case the steering wheel must be removed
proceed as follows;
using a screwdriver. pry out the horn button;
affix puller A. 47039 as shown in fig. 486;
operate the puller and extract the wheel.
Fig. 486 • Pulling the 5teerlng wheel.
1. Puller A. 47033. - 2. Open-end wrench actuafing puller.
SellOnI.' A- A
1
2.
]
I
Fig. 487 • Section view of the steering column and mounting bracket.
1. Universal Joint-fo·column screw and nut. • 2. Upper universal joint. - 3. Ball bearings. - 4. Steering column mounting bracket.• 5. Steering
column. - 6. Ball bearing stop spring•• 7. Universal joint locking groove.
Starting from ear
with
pa,b $Ifla'
N° 7212.
Slzlon. _ SectIon.
Advertisement
Table of Contents
