Fiat 850 Sedan 1968 Shop Manual page 371

IDROCONVERT TRANSMISSION
363
Fig. 589 • Tightening reference for cover retaining nuts.
SERVICING OF MAIN UNITS
Solenoid and Plunger Valve.
Fig. 591 - Fitting Idroconvert transmission casing onto torque
converter.
80
70
I
o
o
]
o
1
I
o
6
o
o
5
09
The following operations may be carried out
without removing the Idroconvert transmission from
the car:
- carefully clean the solenoid outer surfaces
and the surrounding area;
- remove solenoid and ensure that it is work-
ing properly by wiring connector (3, fig. 685) to
the terminal of a 12 V battery; check that the plunger
moves freely and that the plunger stroke is .0295"
(1.5
rom);
- remove plunger valve using service tool
A. 10146/1 (I, fig. 583); the return spring must
come off with the valve;
Fig.
sgo -
Torque converter assembly.
1. Service tool A.
10147
for protection of seals. - 2. Torque con-
verter output shaft. - 3. Torque converter.
Fig. 592 - RefittIng guarantee seal pIn.
1. Spring for torque converter output shaft. - 2. Torque converter
output shaft. - 3. Solenoid. - 4. Plug. - 5. Pin.