Table of Contents
Advertisement
302
FIAT·850 PASSENGER CARS
Fig. 488 - Removing steering column mounting bracket from
instrument panel.
1. Steering column mounting
bracket~to-inslrument
panel screws. -
2. Steering column mounting bracket. • 3. Steering column jacket
screws.
Removing and Disassembling Steering
Column Bracket.
Disconnect steering colunm jackets removing
screws (3, fig. 488) from lower jacket.
Disconnect ignition switch cables and both junction
blocks for outer light and direction signal selector
switch cables.
Remove steering column bracket screws (I,
fig.
488)
from instrument panel.
Lay the steering column, bracket and wheel
assembly down on seat cushion.
.
~
Fig. 489
~
Removing steering wheel on work bench.
1. Ratchet wrench and extension for steering wheel nut. - 2. Ouler
light and direction signal selector switch. - 3. Steering column
mounting bracket.
Fig. 490 - Removing outer light and direction signal selector
switch from steering column.
1. Steering column mounting bracket. - 2. Outer light and direction
signal selector switch. - 3. Key-type ignition switch, also energizing
warning lights and starting circuits.
Remove the universal joint upper screw from
steering colwnn and slide off the steering colunm,
bracket, gear and wheel assembly.
Replacing Steering Column Bearings.
With the steering assembly in above outlined
conditions. renew column bearings as follows:
Fig. 491 • Removing steering column bracket bearing snap
rings.
1. Outer snap ring.• 2. Inner snap ring. - 3. Steering column mount·
ing bracket.
Advertisement
Table of Contents
