Table of Contents
Advertisement
ROADSTER
311
Fig. 516 • Hooking up canvas at rear.
1. Top rear cross rail. - 2. Cross rait hook.• 3. Hook seal.
Folding Top.
The canvas to should be unfolded with much
care because rattles and water leakage may result
if
the top is closed incorrectly.
Proceed as follows.
Raise top recess lid.
Unhook the top fastening strap.
Pull up the top from its stow recess.
Lower the recess lid and hook up the top at rear
(fig. 516).
Fig. 517 • Securing canvas top on sides.
1. Top. - 2. lock pin and plate holding top side.
Fig. 518 • Fastening top at front.
1. Top front cross rail. • 2. Top front catch. - 3. Top front catch
clamp and lever.
Insert side nap lock pins into lock plates (fig. 517).
Secure the top to windshield frame by actuating
catch levers (fig. 518).
At last check to see that drip flaps on top sides
are placed outside door window panes.
Rear Lid for Folded Top.
The top stow recess lid is locked
by
means of
a pair of latches (1, fig. 519) controlled from a turn
handle on lid panel framework.
If the lid latch link (5, fig. 519) must be replaced
remove the center turn handle and disconnect link
ends from latches.
Fig. 519 - Removing folded top recess lid latch link.
1.
lid latches. - 2. Cam pin for latch conlrol. • 3. Top recess
lid.•
4. Lid spring strut. - 5. Lid latch link.
Advertisement
Table of Contents
