Table of Contents
Advertisement
BODY
Padded armrests on door trim panels.
Two sun visors, padded and adjustable, are fitted
on windshield header panel.
Hanger straps, for passengers, are attached to
center pillar posts of body and above the door
window at front, side opposite the driver's. Dress
hook on hanger straps.
Rear view mirror, with courtesy light built in.
Windshield washer pump under the instrument
panel.
Two ash receivers to suit rear passengers, are
en
fitted on side panel trimming.
"' t :
Fig. 388 • Inside view of car door.
1. Inner safely lock knob. - 2. Door lock.· 3. Door handle.· 4. Window
regulator crank. - 5. Ventilator window slop handle. - 6. Ventilator
window.• 7. Drop glass pane.
On cars manufactured starting from the second fortnight 01 April
1966, the ventilator window stop handle Is fitted with a safety push
button.
DOORS
-
249
Disassembly.
To disassemble the door proceed as follows:
Remove the arm rest, the window regulator
crank (4,
fig.
388) and the door latch handle (3).
Remove the door trim panel, overcoming the
force of retaining clips.
Fig. 389 - Removing ventilator window.
1. Ventilator window frame screws. - 2. Ventilator window frame.•
3. Ventilator stop handle and striker plate.
Take down the water shield from inside the door
framing.
Remove the lower front drop glass channel (5,
fig.
392).
Back out ventilator window frame screws (1,
fig.
389).
Crank down the drop glass and remove the
ventilator window, positioning it as shown in fig. 390.
Remove the door lock and remote control (fig. 391).
Fig. 390 - Withdrawing ventilator window assembly.
1. Ventilator window pane.· 2. Ventilator window flame.· 3. Division
bar. - •. Ventilator slop hanQ.le.
Advertisement
Table of Contents
