Table of Contents
Advertisement
ROADSTER
307
Fig. 502 • Fitting templet for drilling antenna rod passage
opening.
1. Templet.• 2. Opening on rear fender for antenna rod passage.
Fig. 504 - Antenna installed on rear fender,
1. Antenna•• 2. Nut, antenna trimmer setting.
RA D I 0
RECEIVER
The
850
Roadster may be optionally fitted with
the same radio receiver as for the Coupe version.
For radio installation proceed as outlined on
page 291 and recall the following additional points.
Using radio
kit
templet drill antenna rod passage
opening (fig.
502)
and arrange the
anteIUla
and
mounting bracket in position.
To secure the antenna assembly to rear wheel-
housing remove the lid from engine compartment
interior and work through the opening in the
wall.
Fig. 503 • Instrument panel with location marks for drilling
radio receiver mounting holes.
1. location marks for drilling receiver mounting
holes.
The antenna bracket mounting holes must be
drilled and the bracket mounted with the antenna
tilted at an angle of 110° toward the rear of the
car (fig.
504).
To install the radio receiver. remove the orna-
mental plate from the right side of instrument panel
and drill necessary mounting holes using marks
stamped on panel lid as a guide (fig.
503).
The loudspeaker (3, fig.
505)
is mounted behind
the utility drawer.
Fig. 50S • Radio receiver installed on car.
1. Tuning control knob.• 2. On-off and volume control knob. •
3. LOUdspeaker.
Advertisement
Table of Contents
