Table of Contents
Advertisement
COUPE
291
•
Fig. 464 • Fitting templet to
drill antenna rod
passage
opening.
1. Templet. - 2. Antenna rod passage opening.
Fig. 466 - Detail showing antenna mounting.
1.
Antenna. - 2. Antenna mounting bracket. - 3. Antenna-lo-radio
receiver cable.
RADIO RECEIVER
The same radio receiver equipping 850 Sedan is
fitted to the Coupe Version.
See page 242 for the installing procedure of the
radio receiver and recall the following additional
points:
- drillings; on upper corner for installation of
aerial (fig. 464), on the instrument panel for instal-
lation of receiver (fig. 465), should be made using
templets included in the radio kit;
Fig. 465 - Fitting templet to drill radio receiver mounting holes.
1. Templet. - 2. Radio receiver mounting holes on instrument
panel.
-
position the antenna assembly with mounting
bracket and tilting it 16
0
toward the windshield
drill the bracket screw and secure the bracket in
place (fig. 466);
-
as clearly shown in fig. 467. the loudspeaker
is arranged in the space between the instrument
panel and the utility floor.
Noise suppression devices should be fitted by
closely adhering to the directions outlined on
page 244.
Fig. 467 - Radio assembly installed on car.
1. Tuning control knob. - On-off and volume control knob. - 3. Loud-
speaker. - 4. Antenna.
Advertisement
Table of Contents
