Table of Contents
Advertisement
ELECTRICAL
243
Fig. 318 - Detail showing the location of the radio receiver
on car.
1. Radio set. - 2. Loudspeaker. - 3. Loudspeaker mounting screws.
- slide in the antenna assembly through the
fender opening drilled previously and secure it by
means of lock ring;
- position the mounting bracket at right angle
to the antenna; drill the opening on the body panel
and secure the bracket as shown in fig. 381; _
- thread the antenna cable through the opening
(II fig. 381) and place the protection grommet
tightly on to the opening.
Next again lay the rubber mat on the wheel-
housing.
Fig. 319. Fitting the templet for d.rilling the antenna rod passage
opemng.
1. Drilling point. - 2. Templet on fender top corner.
Fig. 380 - Fitting the templet for cutting out the instrument
panel lining and fashioning the panel holes, preparatory to
the radio set installation.
1. Templet. - 2. lining slot and instrument panel holes.
Radio Set.
Prior to installing the set, disconnect the positive
cable from. the battery to avoid possible short cir-
cuits during subsequent steps as follows:
-
fit the templet (I, fig. 380) on the instrument
panel lining and cut out the lining following the
slot in the templet;
-
fashion out the holes in the panel as shown
in
fig.
380;
-
working from the bottom, locate the radio set
in place, having the control knob threaded shanks
jut out from their holes;
Fig. 381 • Detail of antenna mounting.
1. Cable, antenna to radio set.• 2. Antenna. - 3. Antenna mounting
bracket. - 4. Bracket screw.
Advertisement
Table of Contents
