Table of Contents
Advertisement
254
FIAT·850 PASSENGER CARS
Fig. 407 _ Removing front bumper.
1. Bumper. _ 2. Bracket gasket. - 3. Bumper bracket.
insert a draw cord in the weatherstrip groove
as shown in
fig.
406;
- clean the windshield contour flange painstak-
ingly with gasoline;
- start the glass with weatherstrip into the wind-
shield opening and working from car interior pull
the ends of the draw cord so that the weatherstrip
is seated snugly, overlapping from opening lip.
To facilitate this step, use a screwdriver (see
fig. 404).
Fig. 408 • Removing rear bumper.
1.
Bumper brackets. - 2. Bumper.
Back Window Glass.
The removal procedure of the back window glass
is the same as for the windshield glass
in
preceding
paragraph.
The only difference is that to push
the glass out from window opening pressure
must be exercised at the base rather than at top
comers of pane.
Rear Quarter Window Glasses.
For removal and installation of these glasses, too,
refer to above paragraphs.
The trim moulding is
fitted by just inserting in the proper slot in rubber
weatherstrip.
NOTE· It
is unnecessary to apply sealing com·
pound when glass panes are installed. lay sealant
just in case of water leakage.
BUMPERS
Removal and installation of bumpers do not
involve special difficulties.
Bumper brackets are mounted in luggage com-
partment at front and in engine compartment at rear.
When fitting the front bumper it is good practice
to insert brackets in body slots alternately, for
easy performance of this step (fig. 407).
SEATS
If
car seats must be taken down for repair.
proceed as follows:
- pull seat adjuster lever and slide front seats
off guide rails at front;
Fig. 409 • Removing rear seat back rest.
Advertisement
Table of Contents
