Table of Contents
Advertisement
ROADSTER
303
- working on bench, take down the wheel (fig.
489) using puller A. 47039;
- loosen the screw which secures the outer
light and direction signal selector switch to steer-
ing colunm bracket:
- slide off the selector switch (fig. 490);
- remove both upper ball bearing snap rings
and cupped washer (fig. 491);
- remove the lower snap ring and working on
top end of shaft have the shaft and the first bearing
slide out (fig. 492); the other bearing can be
easily withdrawn from the bracket without use of
tools ;
- renew parts as required and reverse the
above outlined procedure to reassemble;
- check ball bearings for perfect efficiency and
replace one or both,
if
showing signs of damage.
Fig. 4!l3
Steering system and front end me-
chanical units of car.
Fig. 492 • Removing steering column.
1. Steering column mounting bracket. - 2. Rear ball bearing. -
3. Steering column. - 4. Key.type ignition switch, also energizing
warning lights and starting circuits.
NOTE - From car with No. for spare 801173
1
shoe·to·drum clearance of rear wheels is automatically
adjusted by a self·centering device (as shown in figs. 293 and 294 covering the Sedan version).
Advertisement
Table of Contents
