Replacing basic chassis components
Figure 11: Front bezel
2. Hold the front bezel by the captive screws and lift it toward you. Place it in a secure
To replace the front bezel
When the Avaya CallPilot® server maintenance is complete, replace the front bezel.
1. Align the captive screws on the front bezel with the threaded holes in the front panel.
2. Tighten the captive screws.
Removing and replacing the server cover
Remove the server cover if you must service the interior of the server.
Note:
If a component has a:
70
Avaya CallPilot® 1005r Server Maintenance and Diagnostics
Loosen the captive screws (A) on both sides of the front bezel. The screws cannot
be removed from the front bezel. Refer to
Caution:
Risk of equipment damage
Support the front bezel while loosening the captive screws as the front bezel is
not held onto the front panel with another mechanism.
location while you service the server.
Figure 11: Front bezel
on page 70.
December 2010