Replacing or adding voice processing boards
Figure 49: PCI riser card assembly
9. Turn the riser card upside down and place it on a table.
10. Release the retention clip by loosening the blue captive screw (A).
11. Remove the rear retention screw (B).
12. If the existing MPB96 board is an NTRH40AA, move the board to slot 3.
13. Add the two new boards to the two vacant slots.. Insert and tighten the retaining
116
Avaya CallPilot® 1005r Server Maintenance and Diagnostics
screws (B). Make sure the red power cable is not pinched.
December 2010