Replacing Memory Dimms - Avaya CallPilot 1005r Maintenance And Diagnostics

9. Install the new DVD combo drive in the carrier.
10. Slide the DVD combo drive assembly into the chassis.
11. With the black drive carrier handle in the fully open position, slide the drive assembly
12. Attach the drive power and data cables at the rear of the drive. When the cables
13. Replace the chassis cover.
14. Take the ESD strap off.
15. Replace the front bezel.
16. Reconnect the power cables and peripheral devices.
17. Restart the server.

Replacing memory DIMMs

Four Dual Inline Memory Modules (DIMMs) are installed on your server. You must replace all
four memory DIMMs with those in the Avaya replacement pack. Avaya does not support more
than four DIMM modules in the 1005r server.
Caution:
Risk of equipment damage
Take precautions to protect internal components. Electrostatic discharge (ESD) can damage
cards and make them unusable.
To replace the DIMM cards
1. Power down the server, unplug all peripheral devices and Ethernet cables, and
2. Attach the ESD strap to your wrist and attach the other end to a known grounded
Avaya CallPilot® 1005r Server Maintenance and Diagnostics
d. Remove the three screws that fasten the carrier around the DVD combo
drive.
e. Gently pry open the carrier and remove the DVD combo drive.
a. Line up the pins on each side of the bracket (two on each side) with the
holes in the drive and set the replacement DVD combo drive into the
drive bracket. Push gently on one side of the bracket to push the pins
into place.
b. Screw the carrier shut with the three screws.
c. Reconnect the power and ribbon cables.
back into the chassis.
are firmly installed, the cable retention clips lock into place.
disconnect the AC power.
connection.
Replacing memory DIMMs
December 2010 85