Figure 21: PCI riser card assembly
8. Turn the riser card upside down and place it on a table.
Figure 22: Low-riser PCI card
9. Release the retention bar (A).
10. Replace the card in either slot 2 or 3 (the two upper slots in the preceding diagram
11. Lock the retention bar in place.
12. Turn the PCI riser card right-side up.
13. Arrange the PCI riser assembly red power cable as shown in the following
Avaya CallPilot® 1005r Server Maintenance and Diagnostics
and not the lower slot as shown).
illustration to avoid pinching the cable when you put the riser assembly into the
chassis.
Requirements
December 2010
81