Avaya CallPilot 1005r Maintenance And Diagnostics page 24

Troubleshooting your Avaya CallPilot® system
CMOS Checksum Bad
CMOS Settings Wrong
CMOS Date/Time Not Set
DMA Error
FDC Failure
HDC Failure
Checking NVRAM....
Update OK!
Updated Failed
Keyboard Error
KB/Interface Error
Memory Size Decreased
Memory Size Increased
Memory Size Changed
No Boot Device Available.
Off Board Parity Error
On Board Parity Error
24 Avaya CallPilot® 1005r Server Maintenance and Diagnostics
Error message Description
The CMOS checksum is incorrect. CMOS
memory can be corrupted. Run Setup to
reset the values.
The CMOS values are not the same as the
last boot. Either these values are corrupted
or the battery failed.
The time or date values stored in CMOS are
invalid. Run Setup to set the correct values.
An error occurred during the read/write test
of the DMA (Direct Memory Access)
controller.
An FDC Failure error occurred while trying to
access the diskette drive controller.
An error occurred trying to access the hard
disk controller.
The NVRAM (Non-Volatile Random Access
Memory) is being checked to see if it is valid.
The NVRAM is invalid and has been
updated.
The NVRAM is invalid and cannot be
updated.
An error in the keyboard connection. Make
sure the keyboard is connected properly.
The keyboard interface test failed.
The memory size has decreased since the
last boot. If you have not removed any
memory, then the memory can be faulty.
The memory size has increased since the
last boot. If you have not added any memory,
there is a problem with the system.
The memory size has changed since the last
boot. If you did not add or remove any
memory, then the memory can be faulty.
The system did not find a device to boot from.
A parity error occurred on an offboard card.
This error is followed by the card address.
A parity error occurred in onboard memory.
This error is followed by the card address.
December 2010