Removing The Front Bezel And Server Cover; Introduction - Avaya callpilot 1002rp Hardware Installation

Removing the front bezel and server cover

Introduction

To access the server interior, you must remove both the front bezel and the server cover.
Two locked doors, located on the front of the server, cover the front panel, including the CD-
ROM drive and tape drive. These doors are part of the front bezel. You must unlock the front
bezel doors before you can remove the bezel.
To remove the front bezel
1.
2. Firmly grasp the front bezel by the hand-holds on either side of the chassis, and pull
®
Avaya CallPilot 1002rp Server Hardware Installation
Caution:
Risk of equipment damage
Do not attempt to move or lift the server before removing the front bezel; the
server can disengage from the bezel and fall.
Unlock and open the double doors of the front bezel. See A in the diagram below.
the front bezel from the chassis.
Removing the front bezel and server cover
December 2010 29