Avaya CallPilot 1005r Maintenance And Diagnostics page 93

10. From the Configure menu, select New Configuration. Click Yes to proceed.
11. Create the logical drive by selecting Channel-1 A01-0 and pressing the spacebar.
12. Select A01-02 and press the Spacebar.
13. Press Enter to End the Array.
14. Press F10 to configure the logical drive.
15. Press the spacebar to select Configuration Array.
16. Press F10 to configure the logical drive.
17. Select Accept and press Enter to accept these new values.
18. Select YES and press Enter.
19. Press ESC to exit the submenus.
20. In the Management menu, choose the Initialize submenu.
21. Press F2 to select the logical drive.
Avaya CallPilot® 1005r Server Maintenance and Diagnostics
Mass Storage — Auto Rebuild: Disabled — Initiator ID: 7 — Multiple PCI Delayed
Trans: Disabled — Force Boot: On — Coercion Algorithm: 1GB-way — CC
Restoration: Enabled
Note:
The Coercion Algorithm must be set properly. When changed, it cannot be
changed again without clearing the configuration.
Result: The system displays the SCSI channel with two drives. SCSI IDs are
automatically assigned for each of the two drives. All disk drives must be in READY
state.
Note:
Do not use the Load command on the Configure menu. This command is not for
RAID operations.
Result: The display changes to ONLIN A01-01.
Note:
The drives blink when you select them.
Result: The blinking stops.
Result: Span-1 appears in the box opened for the A01 logical drive.
Result: The system prompts you for the logical drive to consecutively select:
RAID 1; Size: accept the size displayed Accept SPAN = NO
Change the last value to NOSPAN, if required.
Result: The system prompts you to save the configuration.
Result: The configuration is saved. Press any key to continue.
Configuring RAID using LSI320-1 controller and Ctrl+M
December 2010 93