Avaya CallPilot 1005r Maintenance And Diagnostics page 101

Figure 34: PCI riser assembly power cord
14. Reconnect the DS30X or DS30 cable or cables to the MPB96 board or boards. You
15. Hold the PCI riser assembly by the two blue handles (A) and push the assembly
16. Line up the two grooves on the back lip of the PCI riser assembly with the pins on
Avaya CallPilot® 1005r Server Maintenance and Diagnostics
must reconnect each cable to the same MPB96 board to which it was previously
connected. Use the labels you applied in step 4
into the server board. Refer to
the rear panel as shown in the following illustration.
Important:
If the PCI riser assembly is not fully seated, the server can malfunction.
Figure 32: PCI riser card assembly
Requirements
on page 100.
December 2010 101