Avaya CallPilot 1005r Maintenance And Diagnostics page 119

Figure 54: Replacing the riser assembly
19. Hold the PCI riser assembly by the two blue handles (A) and push the assembly
20. Reconnect the PCI riser assembly power cord.
21. Reconnect the CT bus cable.
22. Connect the cables to the MPB96 boards
Figure 55: High capacity rear view
23. Reconnect the SCSI cable to the RAID card.
24. Replace the chassis cover.
25. Take the ESD strap off.
26. Power up the server and log on to Windows.
27. Click Next.
28. Select the presented Avaya MPB driver (there is only one).
29. The Windows New Hardware Found Wizard screen appears again.
30. Click Next.
31. Select the presented Avaya MPB driver (there is only one).
Avaya CallPilot® 1005r Server Maintenance and Diagnostics
into the server board. Refer to
The RJ-45 connectors are numbered from 1 to 3 starting at the right side of the
server next to the power supplies as you face the back panel.
Result: The Windows New Hardware Found Wizard screen appears.
If you are upgradinga pair of High Availability servers, do not complete the next
twosteps. Return to the Procedure "Performing a High Capacity upgrade".
Figure 42: PCI riser card assembly
Requirements
on page 110.
December 2010 119