Avaya CallPilot 1005r Maintenance And Diagnostics page 112

Replacing or adding voice processing boards
12. Remove the rear retention screw (B) as shown in the previous diagram.
13. Replace the card and tighten the screws. Make sure the red power cable to the full-
14. Reconnect the 3-drop CT bus cable (high capacity configuration only).
15. Turn the PCI riser card right-side up.
16. Arrange the PCI riser assembly short red power cable inside the riser assembly as
Figure 45: Full-size PCI riser card red power cable
17. Arrange the PCI riser assembly power cable as shown in the following illustration.
Figure 46: PCI riser assembly power cable
18. Line up the two grooves on the back lip of the PCI riser assembly with the pins on
112 Avaya CallPilot® 1005r Server Maintenance and Diagnostics
size PCI riser card is not pinched.
shown in the following illustration to avoid pinching the cable when you put the riser
assembly into the chassis.
the rear panel as shown in the following illustration.
December 2010