Avaya CallPilot 1005r Maintenance And Diagnostics page 76

Replacing basic chassis components
Figure 16: SCSI hard drive carrier
5. Pivot the latch (A) into the upright position.
6. Pull out on the black lever to slide the carrier from the chassis (B).
7. Remove the new hard drive from its wrapper and place it on an antistatic surface.
8. With the drive circuit-side down, position the connector end of the drive so that it is
9. Align the holes in the drive to the holes in the drive carrier and attach it to the carrier
Figure 17: Hard disk drive location in carrier
10. With the black lever in the fully open position, slide the drive assembly into the
76 Avaya CallPilot® 1005r Server Maintenance and Diagnostics
facing the rear of the drive carrier.
using four screws that meet the drive vendor's recommendation.
chassis.
December 2010