Removing The Processor Port Network Control Cabinet - Avaya S8500 Manual

Migrating to the media server
Hide thumbs Also See for S8500:
Table of Contents

Advertisement

Table 6: Required Migration Hardware 2 of 2
Comcode
NA
106696081
105679542
Removing the processor port network control
cabinet
1
Label both ends of all the cables being removed from all the cabinets. They are reused.
2
Connect a 10 AWG (#25) (2.6 mm
CAP (cable access panel) on the power-failure transfer panel.
3
Route the opposite end of the wire to an approved ground and connect.
4
Power down the cabinets in the SCC1 stack.
5
Remove all circuit packs from the cabinets and place them in an antistatic carrier.
6
Disconnect the cables on the front of the cabinets.
7
Disconnect the cables on the back of the cabinets.
8
Remove all cabinet grounds.
9
Remove the top cabinet.
10
Remove the subsequent cabinets, including control cabinet A and control cabinet B (if high or
critical reliability).
Migrating to the Avaya S8700 or S8710 Media Server
June 2004
Description
CAT5 cables
TN570B Expansion Interface circuit pack (optional)
Z100C Apparatus blank (optional)
CAUTION:
All active calls processed through this port network are dropped when the cabinet stack is
powered down. All trunks and lines within this cabinet stack are down until the cabinet
stack is powered up and the media server controls the port network.
NOTE:
If the system is equipped with Power Failure Transfer (PFT) units using ground start
trunks, you must install a temporary ground wire to the PFT units to allow them to operate
properly when the cabinet is powered down. The AUX cable, that normally supplies the
ground, will be disconnected.
NOTE:
You can cut over to having the media server control the other PNs at this time. Only
cutover at this time if you are not installing IPSI(s) in the PPN or the customer wants to
minimize down time. To cutover, go to
CURL (cannot be reused)
TDM/LAN (reused)
ICC-A, -B (reused)
Converting a processor port network to a port network (SCC)
2
) wire to pin 49 of the connecting block or to pin 49 of the
Enabling control of IPSI(s)
Quantity
1/MedPro
1/C-LAN
1
1 or more
on page 113.
87

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

S8700S8710

Table of Contents