Status Display; Save Setting Display; Decimal Point Display; Fault Message Display - Delta ASDA-A2 Series User Manual

4.3

Status Display

4.3.1 Save Setting Display

After the SET key is pressed, LCD display will show the following display messages for approx. one
second according to different status.
Display Message

4.3.2 Decimal Point Display

Display Message

4.3.3 Fault Message Display

Display Message

4.3.4 Polarity Setting Display

Display Message
Revision April, 2010
Chapter 4 Display and Operation|ASDA-A2 Series
The setting value is saved correctly. [Saved)
This parameter is read only. Write-protected. (Read-Only)
Invalid password or no password was input. (Locked)
The setting value is error or invalid. (Out of Range)
The servo system is running and it is unable to accept this setting
value to be changed. (Servo On)
This parameter is valid after restarting the drive. (Power On)
High/Low byte display. When the data is a decimal 32-bit data,
these two digits are used to show if the display is high byte or low
byte.
Negative value display. When the data is displayed in decimal
format, the most left two digits represent negative sign no matter it
is a 16-bit or 32-bit data. If the data is displayed in hexadecimal
format, it is a positive value always and no negative sign is
displayed.
When the AC servo drive has a fault, LCD display will display
"ALnnn". "AL" indicates the alarm and "nnn" indicates the drive
fault code. For the list of drive fault code, please refer to
parameter P0-01 in Chapter 8 (Servo Parameters) or refer to
Chapter 11 (Troubleshooting).
Positive value display. When entering into parameter setting
mode, pressing UP or DOWN arrow key can increase or decrease
the display value. SHIFT key is used to change the selected digit
(The selected digit will blink).
Negative value display. Continuously press SHIFT key for two
seconds and then the positive(+) or negative(-) sign can be
switched. When the setting value exceeds its setting range, the
positive(+) and negative(-) sign can not be switched. (The
negative value display is for a decimal negative value only. There
is no negative value display for a hexadecimal negative value.)
Description
Description
Description
Description
4-3