Chapter 3 Connections and Wiring|ASDA-A2 Series
7.
The shield of shielded twisted-pair cables should be connected to the SHIELD end (terminal
marked
) of the servo drive.
8.
For the connectors and cables specifications, please refer to section 3.1.6 for details.
3.1.3 Wiring Methods
For servo drives from 200W to 1.5kW the input power can be either single or three-phase. However,
single -phase connections are for servo drives 1.5kW and below only.
In the wiring diagram figures 3.2 & 3.3:
Power ON : contact "a" (normally open)
Power OFF /ALRM_RY : contact "b" (normally closed)
MC : coil of electromagnetic contactor, self-holding power, contact of main circuit power
Figure 3.2 Single-Phase Power Supply Connection (for 1.5kW and below models)
3-4
Revision April, 2010