General Function Operation; Fault Code Display Operation; Jog Operation - Delta ASDA-A2 Series User Manual

4.4

General Function Operation

4.4.1 Fault Code Display Operation

After entering the parameter mode P4-00 to P4-04 (Fault Record), press SET key to display the
corresponding fault code history for the parameter. Please refer to the Figure 4.3.
Figure 4.3

4.4.2 JOG Operation

After entering parameter mode P4-05, the users can follow the following steps to perform JOG operation.
(Please also refer to Figure 4.4).
Step1. Press the SET key to display the JOG r/min speed. (The default value is 20 r/min).
Step2. Press the UP or DOWN arrow keys to increase or decrease the desired JOG speed. (This also
can be undertaken by using the SHIFT key to move the cursor to the desired unit column (the
effected number will blink) then changed using the UP and DOWN arrow keys. The example
display in Figure 4.4 is adjusted as 100 r/min.)
Step3. Press the SET key when the desired JOG speed is set. The Servo Drive will display "JOG".
Step4. Press the UP or DOWN arrow keys to jog the motor either N(CW) and P(CCW) direction. The
motor will only rotate while the arrow key is activated.
Step5. To change JOG speed again, press the MODE key. The servo Drive will display "P4 - 05".
Press the SET key and the JOG r/min speed will displayed again. Refer back to #2 and #3 to
change speed.
NOTE
1) JOG operation is effective only when Servo On (when the servo drive is enabled).
Revision April, 2010
Chapter 4 Display and Operation|ASDA-A2 Series
4-7