Remove The Defective Hard Drive From The S8510 Server - Avaya S8510 Manual

Job Aid: Replacing the hard drive on the Avaya S8510 server
Note:
Only the two-color drive status LED provides fault condition information; the
Note:
single-color drive activity LED does not.
Table 1: S8510 drive status indicators
Drive status LED pattern
Off
Flashes green, amber, and off
Flashes amber four times per second
Flashes green slowly
Steady green
Flashes green three seconds, amber three seconds,
and off six seconds
3. Determine which slot number holds the defective hard drive and proceed with
defective hard drive from the S8510 server

Remove the defective hard drive from the S8510 server

!
WARNING:
Do NOT remove the healthy, active hard drive. If you inadvertently remove the
WARNING:
active hard drive, you cannot plug it back in. You must:
- Contact the customer and arrange for a maintenance window.
- When the maintenance window starts, cleanly power down the server.
- Re-insert the active hard drive in its original slot.
- If still installed, remove the drive from the other slot, mark it "bad," and set it aside.
- Power-up the server with only the healthy drive present and confirm normal
operation when the server comes up.
- Proceed with replacing the defective hard drive.
To remove the defective hard drive from the S8510 server:
1. Pinch the two tabs of the drive carrier release handle together (Note 1 in
replace the hard drive on the S8510 server (bay 1 shown)
38 Job Aids for Field Replacements (FRUs) for the Avaya S8510 Server
Description
Drive ready for insertion or removal
Drive predicted failure
Drive failed
Drive rebuilding
Drive online
Rebuild aborted
on page 38.
on page 39).
Remove the
Figure 9: Remove/