Replacing A Power Supply In The S8510 With Dual Power Supplies; Remove The Defective Power Supply - Avaya S8510 Manual

Job Aid: Replacing the power supply on the Avaya S8510 Server
Replacing a power supply in the S8510 with dual power
supplies
Note:
If the S8510 Sever has two power supplies, you do not have to power down the
Note:
server to replace the defective, redundant power supply.

Remove the defective power supply

!
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the power supply or
WARNING:
power supply blank to cool before touching it.
To remove the defective power supply:
1. Open the cable management arm, if present, to access the rear panel.
2. Identify the defective power supply by looking for the power supply fault indicator (Note 2 in
Figure 18).
Note:
The power supply fault indicator is the same on both power supplies.
Note:
Figure 18: S8510 power supply LEDs (bay 1 shown)
Figure notes:
1. Power supply status indicator
2. Power supply fault indicator
62 Job Aids for Field Replacements (FRUs) for the Avaya S8510 Server
1 Gb 2
Gb
3. AC line status indicator
1
2
3
hw85pled LAO 050108