Install The Replacement Dual Nic In The S8510 Server; Replace The Cover On The S8510 - Avaya S8510 Manual

Install the replacement dual NIC in the S8510 server

To install the replacement dual NIC in the S8510 server:
1. Carefully grasp the replacement NIC by its edges and position it so that the card-edge
connector aligns with the expansion-card slot on the PCI riser board (Note 2 in
Figure 13: Removing and replacing the dual NIC in the S8510 server
2. Insert the card-edge connector firmly into the PCI expansion card riser until the card is fully
seated.
3. Close the PCI expansion card riser latch (Note 1 in
dual NIC in the S8510 server

Replace the cover on the S8510

To replace the cover on the S8510 server use
server on page 52 in reverse order.
!
WARNING:
Ensure that the SAMP cable and any other internal cables are clear of the cover
WARNING:
before replacing it on the server.
1. Place the cover on top of the server, aligning it with the J hooks on the sides.
Install the replacement dual NIC in the S8510 server
Figure 13: Removing and replacing the
on page 50).
Figure 14: Replacing the cover on the S8510
on page 50).
03-602953 Issue 1 June 2008 51