Label And Disconnect Cabling - Avaya S8510 Manual

Figure 20: Avaya S8510 front panel
1 2
III
Figure notes:
1. Power-on indicator, power button
2. Nonmaskable Interrupt (NMI) button
(disabled)
System identification button (used to
3.
locate equipment within the rack)
4. LCD display (system ID, status
information, and system error
messages)
3. Continue only after the server has powered down and the power-on indicator light (Note 1 in
Figure 20) is out.

Label and disconnect cabling

Be sure to label and disconnect the following connections:
1. Label and disconnect the power cord(s) from the power supply(ies) at the back of the
server.
2. Label and disconnect the Ethernet cable from the dual NIC at the back of the server.
3. Label and disconnect the power cord from the SAMP at the back of the server.
4. Label and disconnect the USB modem cable from the USB port on the SAMP at the back of
the server.
5. Label and disconnect the LAN connection (if used) from the Ethernet port on the SAMP at
the back of the server.
3 4 5 6
0
8
Replacing the SAMP on the Avaya S8510 server
1
7
5. USB 2.0 connectors
6. Video connector (not used)
Hard disk drives
7.
8. Slimline CD/DVD drive
03-602953 Issue 1 June 2008
hw8510fn LAO 020108
67