Label And Disconnect Cabling; Remove The S8510 Server From The Rack - Avaya S8510 Manual

Job aids for field replacements (frus)

Hide thumbs Also See for S8510:

Table of Contents

Label and disconnect cabling

Be sure to label and disconnect the following connections:

1. Label and disconnect the power cord(s) from the power supply(ies) at the back of the

server.

2. Label and disconnect the Ethernet cable from the dual NIC at the back of the server.

3. Label and disconnect the power cord from the SAMP at the back of the server.

4. Label and disconnect the USB modem cable from the USB port on the SAMP at the back of

the server.

5. Label and disconnect the LAN connection (if used) from the Ethernet port on the SAMP at

the back of the server.

To remove the S8510 server from the rack:

1. Ensure that all cables are labeled and disconnected from the server.

2. Loosen the captive screws on both sides of the server (Note 1 in

S8510 server from the rack

on page 48).

Label and disconnect cabling

Figure 11: Remove the

03-602953 Issue 1 June 2008

Table of Contents