Install The Replacement Samp In The S8510 Server; Replace The Cover On The S8510 - Avaya S8510 Manual

Install the replacement SAMP in the S8510 server

To install the replacement SAMP in the S8510 server, refer to
the S8510 SAMP card
1. Connect the ribbon portion of the replacement SAMP cable assembly to the motherboard
(Note 4 in
2. Carefully grasp the replacement SAMP by the outer edges and align it with the opening on
the PCI expansion slot riser assembly. Press the SAMP firmly into the expansion slot (Note
3 in Figure 23: Removing/replacing the S8510 SAMP card
!
CAUTION:
Make sure the SAMP card is completely seated in the expansion slot before you
CAUTION:
apply power to the S8510 server. Incomplete insertion might cause damage to
the system board or to the SAMP card.
3. Connect the other end of the replacement SAMP cable assembly to the SAMP (Note 2 in
Figure 23: Removing/replacing the S8510 SAMP card
4. Press the PCI expansion card riser release latches (Note 1 in
replacing the S8510 SAMP card

Replace the cover on the S8510

To replace the cover on the S8510 server use
server on page 74 in reverse order.
!
WARNING:
Ensure that the SAMP cable and any other internal cables are clear of the cover
WARNING:
before replacing it on the server.
1. Place the cover on top of the server, aligning it with the J hooks on the sides.
on page 72 and using the steps in reverse order:
Figure 23: Removing/replacing the S8510 SAMP card
Replacing the SAMP on the Avaya S8510 server
on page 72) to secure the SAMP and the riser assembly.
Figure 24: Replacing the cover on the S8510
Figure 23: Removing/replacing
on page 72).
on page 72).
on page 72).
Figure 23: Removing/
03-602953 Issue 1 June 2008 73