Job Aid: Replacing The Samp Power Supply; Required Materials; Replacing The Samp Power Supply For The S8510 Server; Remove The Defective Samp Power Supply From The S8510 - Avaya S8510 Manual

Job Aid: Replacing the SAMP power supply

!
Important:
Always check the Avaya Support Website for Product Support Notices at
Important:
support.avaya.com/japple/css/
japple?PAGE=ProductArea&temp.productID=162774.
This Job Aid contains procedures to replace the SAMP power supply for the S8510 server.
!
Important:
Ensure that you have the proper replacement power supply for the SAMP. The
Important:
replacement parts are not interchangeable.

Required materials

Verify that you have the following equipment on site:
SAMP Board power supply, Material ID 700405012
•
!
Important:
Ensure that the replacement power supply is Material ID 700405012 only. You
Important:
cannot interchange SAMP power supplies.

Replacing the SAMP power supply for the S8510 server

Remove the defective SAMP power supply from the S8510

To remove the defective SAMP power supply from the S8510 server you do not need to
power-down the server:
1. Remove the SAMP power supply plug from the power source.
2. Remove the power connection from the SAMP board's RJ11 connector on the rear panel of
the S8510 server.
03-602953 Issue 1 June 2008
http://
77