Table of Contents
Advertisement
Job Aid: Replacing the hard drive on the Avaya S8510 server
Additional information
The following Avaya S8510 document might be helpful:
Installing the Avaya S8510 Server and its Components (03-602918)
•
Replacing either hard drive in the S8510 server
The following steps are required to successfully replace either hard drive in the S8510 server:
Back up the system
•
Remove the front bezel from the S8510 server
•
Identify the defective drive
•
Remove the defective hard drive from the S8510 server
•
Install the replacement drive in the S8510 server
•
Replace the front bezel
•
Monitor the drive rebuild
•
Return the defective equipment
•
Back up the system
!
CAUTION:
This hard drive replacement procedure can destroy data stored on the hard drive.
CAUTION:
Before replacing either hard drive, perform a server data backup if server access
is possible.
To back up the data on the S8510 Server:
1. Connect your laptop to the server's service port using the crossover cable.
2. At a browser on your laptop log in to the Maintenance Web Pages (192.11.13.6).
Note:
You might need to clear the ARP cache on your laptop (issue the arp -d
Note:
192.11.13.6 command from the laptop's command line) before you connect to
the Maintenance Web Pages.
3. At the Maintenance Web Pages select Data Backup / Restore > Backup Now.
The Backup Now page displays.
34 Job Aids for Field Replacements (FRUs) for the Avaya S8510 Server
Advertisement
Table of Contents
