Siemens HiPath 3000 Series Service Documentation page 362

Table of Contents

Advertisement

boards.fm
Boards for HiPath 3000
Peripheral boards
Configuring S
interfaces
0
Depending on how the interfaces are applied, use HiPath 3000/5000 Manager E to define the
relevant protocols for the trunks to be connected. Please note the additional information con-
tained in the protocol templates when selecting a suitable S
CO = Interfaces to the public CO
Bus = Interfaces to an internal station
Master = Interfaces for a master system network
Slave = Interfaces for a slave system network
H150/H118 or H300 = Defines the CorNet protocol:
H150/H118 = Optimized for interconnection with HiPath 3000
This setting should also be selected in connection with HiPath ProCenter Office HP-
CO.
H300 = Optimized for interconnection with HiPath 4000
Direct or fixed connection: defines the type of connection for a network and controls the
supply of clock pulses:
Direct = Communication systems are connected to one another by means of a direct
cable connection. The master system supplies the reference clock pulse for the net-
worked system.
Fixed connection = Communication systems are connected over lines leased from a
network provider (with clock pulse supply). The master system receives the reference
clock pulse from the network.
A slave system always receives the clock pulse from the master system regardless of
whether the connection is direct or fixed.
Use the S
interface S
0
also connect S
interfaces S
0
group 4 fax device, PC, dialing aid) via an S
3-230
1 for connection to the public telecommunications network. You can
0
2 to S
4 to the ISDN trunk or to ISDN terminals (ISDN telephone,
0
0
protocol:
0
bus.
0
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
Nur für den internen Gebrauch

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents