Slcn (Not For U.s.) - Siemens HiPath 3000 Series Service Documentation

boards.fm
Boards for HiPath 3000
Peripheral boards
3.3.14

SLCN (not for U.S.)

NOTE
>
Danger of damage to property due to surge voltage. The required lightning protec-
tion measures must be taken for this board, see Section 2.1.2, "Lightning Protec-
tion".
Introduction
The SLCN (Subscriber Line Module Cordless New) board is used in HiPath 3800 and connects
base stations to HiPath Cordless Office. There are 16 U
You can install up to four SLCN boards in one system.
Chapter 11 contains basic information on the options available for operating HiPath Cordless
Office.
Base stations must be clocked with a high degree of accuracy for HiPath Cordless Office. For
this, the subboard CMS
Front panel
Two LEDs indicating the board status:
LED (red)
●
LED (green)
●
Figure 3-56 SLCN (not for U.S.) (S30810-Q2193-X300) - LEDs in the Front Panel
An additional shielding panel is not required on the front side of this board, because the EMC
shield is already provided by the front panel.
3-150
must be plugged into the
Nur für den internen Gebrauch
ports available for this.
P0/E
CBSAP board (see Table 11-1).
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation