Inserting Powerbox Pb3000 - Siemens HiPath 3000 Series Service Documentation

exup.fm
Expanding and Upgrading HiPath 3000
HiPath 3000Expanding
9.1.3

Inserting Powerbox PB3000

Danger
7
The Powerbox PB3000 must be operated with a closed housing.
Before opening the housing, disconnect the PB3000 from the power supply by:
turning the switch for the line voltage on the front panel of the PB3000 to the
●
"Off" position.
turning the switch for the battery voltage on the back side of the PB3000 housing
●
to the "Off" position.
removing the battery fuse (back side of the PB3000 housing).
●
unplugging all power and connection cables.
●
Introduction
The Powerbox PB3000 is the compatible successor to the expansion cabinet EBR. The EBR
is being discontinued and can no longer be ordered.
The Powerbox PB3000 is needed in a system:
for emergency battery operation in the event of power failure; i.e., if an uninterruptible pow-
●
er supply function is required.
if the internal system power supply unit for the HiPath 3000 is not sufficient to provide pow-
●
er to all connected terminals (corded or cordless).
The PB3000 can be equipped with:
4 batteries, each 12 V / 7 Ah and/or
●
the LUNA2 power supply
●
The PB3000, the batteries and the LUNA2 power supply are supplied in a separate package.
Caution
7
To avoid transport damage, Powerbox PB3000 must not be transported with the bat-
teries installed.
The batteries should be installed as described in Section 9.1.3.6.1. Only use batteries ap-
proved for HiPath 3000. The LUNA2 power supply should be installed as described in Section
9.1.3.6.2.
9-6
Nur für den internen Gebrauch
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation