Stacking Two Cabinets - Siemens HiPath 3000 Series Service Documentation

Table of Contents

Nur für den internen Gebrauch

Stacking Two Cabinets

To guarantee sufficient ventilation for the system cabinets, comply with the following

requirements:

The basic cabinet must be set up as the bottom cabinet.

Allow a minimum of 50 mm clearance between the base of the cabinet and the

floor, and between basic and expansion cabinets.

Place the system cabinet in the installation site and make sure that it is level and

Check that the space between the base of the basic cabinet and the ground is at

least 50 mm.

If necessary, set up the basic cabinet in the following way:

Unscrew lock nut (Figure 4-1, A) on one of the cabinet feet using an open-end

wrench (wrench size = 13 mm).

Adjust the height of the cabinet foot by turning the screw nut (Figure 4-1, B)

so that the cabinet is steady and the minimum clearance is observed.

Fix the cabinet foot in position by tightening the lock nut (Figure 4-1, A).

Place the expansion cabinet on top of the basic cabinet.

The cabinet feet have indents. When placing the expansion cabinet on top of the

basic cabinet, ensure that these indents are sitting precisely on top of the screw

heads in the four corners of the basic cabinet (Figure 4-2).

Check that the space between the base of the basic cabinet and the ground is at

least 50 mm.

If necessary, set up the expansion cabinet as described in Step 3.

A31003-H3590-S100-7-7620, 06/2012

HiPath 3000/5000 V9, Service documentation

Installing HiPath 3000

Installing HiPath 3800

Show Quick Links

Table of Contents