Gee12 (Not For U.s.), Gee16 (Not For U.s.), Gee50 (Not For U.s.) - Siemens HiPath 3000 Series Service Documentation

boards.fm
Boards for HiPath 3000
Options
3.4.8

GEE12 (not for U.S.), GEE16 (not for U.S.), GEE50 (not for U.S.)

NOTE
>
Danger of damage to property due to surge voltage. The required lightning protec-
tion measures must be taken for this board, see Section 2.1.2, "Lightning Protec-
tion".
Introduction
Each of the modules listed below supports four call-metering receiving units for recording and
preprocessing call charge pulses in HiPath 3550 and HiPath 3350.
Table 3-181 GEE12/GEE16/GEE50 (not for U.S.) Modules
Module Frequency
GEE 12 12 kHz
GEE 16 16 kHz
GEE 50 50 Hz
The call charge detection channel is looped in the trunk and then routed to the TLA
Interfaces
to the TLA
To CO
LS
Figure 3-138 GEE12, GEE16, GEE50 (not for U.S.) - Interfaces (S30817-Q951-Axxx)
3-374
also for Silent Reversal
1
X3
10
1
GEE module
X4
8
Remarks
CB side
1 10
X5
Board side
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
Nur für den internen Gebrauch
X1
X2