Installing Batteries In Pb3000 - Siemens HiPath 3000 Series Service Documentation

Nur für den internen Gebrauch
9.1.3.6.1

Installing Batteries in PB3000

Danger
7
The only batteries approved for connection are V39113-W5123-E891 (12 V/7 Ah).
The use of other battery types is prohibited.
Note on recycling:
Old batteries with this symbol are utilizable economic units and must be re-
cycled. Old batteries that are not recycled are to be disposed of as special
refuse in accordance with all requirements.
The PB3000 and batteries are packaged separately and included in the delivery. Proceed as
follows to install the batteries in the PB3000:
Step
1. Turn the switch for the line voltage on the front of the PB3000 housing and the
switch for the battery voltage on the back of the PB3000 housing to the "Off" po-
sition (see Section 9.1.3.1).
2. Remove the battery fuse on the rear of the PB3000 housing (see Section 9.1.3.1).
3. Unplug all of the power and connection cables of the PB3000.
4. Remove the front panel of the PB3000: to do so, remove the four screws.
5. Pull the plug-in battery module out of the left housing compartment.
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
Expanding and Upgrading HiPath 3000
Activity
exup.fm
HiPath 3000Expanding
9-19