4 Repair
4.5.6 Replacing the complete lower arm
Continued
6
7
8
Continues on next page
412
Action
Secure the cable harness with a cable tie.
Make sure that the gasket on the cover is
correctly fitted.
Note
Replace if damaged.
The gasket is covered with adhesive on the
side facing the upper arm cover. The three
washers are pressed into the holes in the
gasket. Make sure all three washers are
fitted.
Refit the cover.
© Copyright 2015-2018 ABB. All rights reserved.
Note
xx1500003093
xx1500003094
xx1500002722
Product manual - IRB 8700
3HAC052853-001 Revision: F